Share your ROUTE v2.0 Experience

@lechu
yep.After review one last.
i think it is D too
thank you!

Hi guys, please share dumps with me please, thank you

my email

phuoc.nch@gmail(.)com – please remove ()

@Stranger, congrats and thanks for the feedback!

please share the latest dumps. email: al-z3eem929 @ hotmail. com

Hi everyone, I passed the exam today. Thank you everyone esp. Digitaltut and Route rider. Spoto 227 and 2.73 with 250q is valid. Good luck to all for their prep :)

@Anonymously, could you please share your dump for me, please?

My email is: phuoc.nch@gmail(.)com – please remove ()

Dumps link on page 270 you can download

Hi guys, please share dumps with me please, thank you

tonpereira at hotmail dot com

x t i a n 2 4 7 4 @ gmail.com

for dumps search the post “Router Learning”

Hello ,
i passed yesterday 9xx ,
all questions was from MPQ and New Updated Questions – Part 5 sections

Sim: OSPF virtual link, EIGRP stub, EIGRP Evaluation
D&D are from here to .

Thank you digitaltut !!

May I have the Latest Spoto and Route-dec 2018. Please.
Thank you in advance.

mss 279970 @ gmail . com

Failed yesterday with 75x points….
labs (OSPF, EIGRP STUB and EIGRP evaluation) were on point

However around 15 questions I’ve never seen before, not even on ROUTE_DEC_2018

Can someone answer the following questions? (they were on the EXAM last week)

Which two statements about GRE tunnel interfaces are true? (Choose two)
A. To establish a tunnel the source interface must be m the up/up state.
B. To establish a tunnel the source interface must be a Joopback.
C. A tunnel destination must be a physical interface that is the up state.
D. A tunnel destination must be routable but can be unreachable.
E. A tunnel can be established when the source interface is in the up/down state.

NO.75 A network engineer is enabling conditional debugging and execute two command. Debug condition interfaces serial00 and debug condition interfaces serial 0/1. Which debugging output is displayed as a result?
A. interface cannot be used as a debug condition.
B. Output is display for both specified interfaces.
C. Output is display for interface serial 0/1 only.
D. Output is display for interface 0/0 only.

Which NAT command do you enter to disable dynamic ARP learning on an interface?
A. R1(config-if)#ip nat enable
B. R1(config-if)#ip nat inside
C. R1(config)#ip nat service
D. R1(config-if)#ip nat outside
E. R1(config)#ip nat allow-static-host

NO.153 Which command prevents routes from sending routing updates through a router interfaes? A. distribute-list in
B. passive-interface
C. default-metric
D. distribute-list out

@Thank you mate, found dumps on page 270

Anyone who has nnneeetwworking dump 757Q please share.

My email is phuoc.nch@gmail(.)com – please remove ()

Can someone share with me SPOTO 227 and Q757? I have been looking through the comments pages, but couldn’t find anything.

Email: al-z3eem929 at hotmail .com

Thanks.

Failed yesterday with 75x points….
labs (OSPF, EIGRP STUB and EIGRP evaluation) were on point

However around 15 questions I’ve never seen before, not even on ROUTE_DEC_2018

Correction; those 15 questions I found later on in the v23.75 sheet, but this one has a lot of wrong answers, can someone post the 23.75 with the correct answers?

Which two statements about DMVPN are true? (Choose two.)

A. IPsec encryption not supported with statically addressed spokes.
B. It requires full-mesh connectivity on the network.
C. It uses NHRP to create a mapping database of spoke addresses.
D. Multicast traffic is not supported.
E. It supports dynamic addresses for spokes in a hub-and-spoke VPN topology.

Is it not C and E ? had this question on my exam and I chose A and C

BOss
could you refer me to these question ? copy it’s site in comment below plaz

@Boss
I believe that C and E are the correct:
What is Dynamic Multipoint VPN ?
• Dynamic Multipoint VPN (DMVPN) is a combination
of GRE, NHRP, and IPsec
• NHRP allows the peers to have dynamic addresses
(ie: Dial and DSL) with GRE / IPsec tunnels
• Backbone is a hub and spoke topology
• Allows direct spoke to spoke tunneling by auto
leveling to a partial mesh

ref: https://www.cisco.com/c/dam/en/us/products/collateral/security/dynamic-multipoint-vpn-dmvpn/prod_presentation0900aecd80313c9d.pdf

Which two statements about GRE tunnel interfaces are true? (Choose two)
A. To establish a tunnel the source interface must be m the up/up state.
B. To establish a tunnel the source interface must be a Joopback.
C. A tunnel destination must be a physical interface that is the up state.
D. A tunnel destination must be routable but can be unreachable.
E. A tunnel can be established when the source interface is in the up/down state.

Correct : AD

NO.75 A network engineer is enabling conditional debugging and execute two command. Debug condition interfaces serial00 and debug condition interfaces serial 0/1. Which debugging output is displayed as a result?
A. interface cannot be used as a debug condition.
B. Output is display for both specified interfaces.
C. Output is display for interface serial 0/1 only.
D. Output is display for interface 0/0 only.

B

Which NAT command do you enter to disable dynamic ARP learning on an interface?
A. R1(config-if)#ip nat enable
B. R1(config-if)#ip nat inside
C. R1(config)#ip nat service
D. R1(config-if)#ip nat outside
E. R1(config)#ip nat allow-static-host

E

NO.153 Which command prevents routes from sending routing updates through a router interfaes? A. distribute-list in
B. passive-interface
C. default-metric
D. distribute-list out

B or D , explanation you can find on pages earlier

Which two statements about DMVPN are true? (Choose two.)

A. IPsec encryption not supported with statically addressed spokes.
B. It requires full-mesh connectivity on the network.
C. It uses NHRP to create a mapping database of spoke addresses.
D. Multicast traffic is not supported.
E. It supports dynamic addresses for spokes in a hub-and-spoke VPN topology.

C E

QUESTION 664
Which value determines the amnount of traffic that a network path can hold in transit?
A. route cacshe setting
B. maxsimum windows size
C. badwidth delay product
D. MSS

C

QUESTION 665
Which location within the network is preferred when using a dedicated route for Cisco IP SLA operations?
A. uswser edge
B. provider edge
C. access edge
D. distribution edge

B

I suggest to read the appropriate subjects and correct the answers by myself

regards

Hi @Marinela Pavlova, how to get 758q dump for 300-101? If you have can you please share with barisozensel @ gmail . com
I would be appriacte if you do.
btw guys is the 227q valid? does anyone confirm it?

Why are people posting switch questions on a route platform?

Does anyone have Shikander Shaikh’s CCNP route workbook?

Please share the lastest dump at asnllthegunnerr @ gmail.com. Is spoto 227q still valid guys?

passed today. Lots of new questions. OSPF stub and eigrp stub lab. EIGRP evaluation. Goodluck to all

Anyone here can justify the best answer for this question because in Dec_2018 the answer either EIGRP or BGP but most of the other dump answer was BGP :D please enlighten me

********************

Which routing protocol routes traffic through the best path and second best path at the same time?
A. EIGRP
B. BGP
C. OSPF
D. RIP

@lechu

Can you shard your dumps with me, please?

Email id: dhanaraj.tamilarasu at gmail dot com

@JJ or any one have..
If you have spoto 248q and 300-101 V23.75.pdf
pls send to me
n.sniper01 at gmail dot com

anyone here knows the answer for this question im little bit confuse between A or D

*******
router eigrp 1
redistribute ospf 5 match external route-map OSPF-TO-EIGRP metric 10000 2000 1 255 1 1500
route-map OSFP-TO-EIGRP
match ip address TO-OSPF

Refer to the exhibit
Which routes from OSPF process 5 are redistributed into EIGRP?
A. E1 and E2 subnets matching access list TO-OSPF
B. E1 and E2 subnets matching prefix list TO-OSPF
C. only E2 subnets matching access list TO-OSPF
D. only E1 subnets matching prefix listTO-OSPF

If you have spoto 248q and 300-101 V23.75.pdf
pls send to me

mss 279970 @ gmail . com

Digitaltut in your dumps (ROUTE_Dec_2018.pdf) mistake q71.

B is the right answer B. E1 and E2 subnets matching prefix list TO-OSPF

Can somebody tell me how to take premium membership here? I don’t see any option to login or purchase…

Which two statements about DMVPN are true? (Choose two)
A. IPsec encryption not supported with statically addressed spokes
B. It requires full-mesh connectivity on the network
C. It uses NHRP to create a mapping database of spoke addresses
D. Multicast traffic is not supported
E. It supports dynamic addresses for spokes in a hub-and-spoke VPN topology
Answer: A C

Maybe C and E ?

i need SPOTO-248 file.
send me on this email: sysdigi001 @ gmail . com

Can someone please share Spoto and 300-101-v23.75 pdf is possible. I’d really appreciate it thanks in advance.
jubeeyste @ gmail dot com

Thanks once again. You’d be a life saver.

Can anybody send me exam 300-101 PDF please chi_126 @ hotmail.com it’s appreciated

I passed ROUTE exam, go through recently added questions, D&D and labs before the exam. Digitaltut information is more than enough to clear the exam.

@Nicholas Giancola

The New PL dumps look like the Spoto dumps. Is there anything new on them?

@JJ and any one have dumbs 248Q
If you have spoto 248q and 300-101 V23.75.pdf
pls send to me
n.sniper01 at gmail dot com

Any one have dumbs 248Q
If you have 248q ,300-101.pdf
pls send to me
n.sniper01 at gmail dot com

May I have the lastest dump ccnp route at : mamine*kheireddine*@*outlook*fr
remove the *
thank you, really appreciate

Hi Guys, can anyone please send me the latest dump for ROUTE exam at nj732800 at gmail dot com?

Thanks for your help

please send lastest to shottas at gmail dot com

CAN ANYONE SHARE THE LATEST UPDATED DUMPS. I WAS TRYING TO FIND IN PREVIOUS PAGES BUT WASN’T SUCCESSFUL. THANKS

Pass. All questions was from “www digitaltut com route-questions-and-answers” 100% from it. Especially latest questions in this pdf. Thanks to people who post it there couple of pages ago. Thank you digitaltut, for my next exam I’ll buy premium for your help with routing exam.
I hate this exam because of here is so many useless things like Frame relay and IPv6. Learn dumps and forget about it as a nightmare.

Hi, do you know similiar website for Vmware exams?

Hi @ all,

¿what is 00-101-v23.75 pdf? ¿On what page can I find it?